** The photo remains the same as the conventional product, but the wire wire was replaced with a brass line.. (Photo 7) This allows you to solder neatly without using a flux for sheet metal..

● The LED cube has a 5mm diameter of 4 × 4 × 4 blue LEDs ON, OFF, plane moving, swing, rain, fireworks, frame display, etc.. Unlike the photo, the LED of the kit is attached to the blue LED with a blue cap.. (Photo 5) The brightness is uniform and there is no hassle of file.. If there is a successful bidder, we will make a board, so we will ship it in the shortest three days..

● In addition to the production manual, substrate, electronic components, brass wire, screws, nuts, acrylic bottom plate, etc., it also includes wooden formworks.. It is about 150mm x 100mm, 110mm in height. The maximum current (when all lighting) is about 0.8a. Power is not included. Attach a used power supply of 5V1A for 500 yen as an option. (The power supply in the photo is an example.) If it is difficult to hit the LED or brass wire, the finished product will be produced with an adjustment shipping fee of 1700 yen (non -standard -specific mail).. Please change the amount of money by changing the shipping fee by hand.. If the kit cannot be completed, it will be repaired for shipping + repair parts + 1000 yen assembly fee..

● The LED cube program has been written on the attached 28 -pin PIC microcomputer.. A CD with a circuit diagram (MPLAB assembler for 16F876) is attached, so if you have knowledge of the program, please remodel and play freely.

● Production is explained with photos, so I don't think you will get lost.. A slightly softer brass wire 0.9φ ( # 20) is used horizontally and vertically.. We will support you until completion.

● Slide switch and acrylic bottom plate are reused. The bottom plate has pickpockets and holes.

● Other various works are introduced on HP (http://tawaketago.me)..

● In the case of a kit, the shipping fee is 370 yen for a letter pack.

No questions.