Thank you very much for seeing it. ■ Jazz BASS / Jazz Base Tooguruschi Installation type Control / plate Stainless steel is exhibited. (No.jzp-25 TS)
● Jazz Bass / Jazz Base Control / Plate ------- 1 sheet
Toglu switch mounting type, stainless steel, No.jzp-25 TS
Material: Stainless steel 2B specification / SUS304, plate thickness: 2.35mm,
Body mounting screw hole x 3/ diameter: 4mm
Pot mounting hole x 2/ diameter: 9.5mm
Toogurusch mounting hole x 1 / diameter: 12.0mm
Fawn jack mounting hole x 1 / diameter: 9.5mm
·surface treatment:
Paper disk polishing / buff polishing on both the front and back side, hair line
The left mirror polishing process was performed. Fine scratches of polishing marks on the polishing surface and fine pinholes of the material itself
remain. ▲ Product description:
・ Self -made hand -made hand, such as cutting out, grinding, drilling holes, polishing, etc.
I will exhibit a craft product. ● Basically made as the size of the control plate for inch size
I did. Unlike the specifications of general control plates, you can attach a toogle switch
As we are doing so, you can switch between front and rear pickups.. About the shape and dimensions of jazz -based control plates
It seems that there are several types depending on the product number, so this product is the second image.
The body mounting hole pitch of the plate is listed. The hole diameter for the screw is made of 4 mm diameter holes.. The mounting hole pitch between the screws at both ends of the Yamagata part on the bridge side of the plate is
It is according to the masterpiece plate on hand. *Bis -gap holes pitch on both ends: 49.4mm
A plate that exists for jazz bass (actual machine mounting, commercially available product, etc.)
The gap holes pitch at both ends are 49mm, 50mm, or 49mm to 50mm.
It seems that there is a plate of the dimensions between them. The hole diameter for screws is a 4mm diameter hole, so the screws used.
Depending on the size, the screws between screws at both ends are within the range between 49mm and 50mm
The guitar body is also compatible with plate mounting.. The jack hole system is 9.5mm diameter so that it can be attached by switch craft.
doing. To be able to attach a pot (24mm/volume and tone) made by CTS
The hole diameter is 9.5mm. The hole diameter for the toogurusch is 12.0mm. *Please refer to the third image. This product was made by hand by hand. ・ The material is a strong and corrosion -resistant stainless steel SUS304. Please use it by all means. ***************************For those who can understand, please bid with no claim no return. Please note that there may be times when contacting here may be delayed due to work.