The booster has been miniaturized and renewed.
● Supported frequency: AM 500kHz ~ 1800kHz FM 60kHz ~ 90kHz
● Booster Gain: AM 10db ± 2db FM/VICS 15DB ± 1db
● Voltage: dedicated to DC12V
● Current: 50mA
● Output impedance: 75Ω
● Antenna plug: Standard radio plug JASO
● Film size: 25 x 266mm
● Cable length: 2 + 1m
Color: Booster part Black, Film Antenna Partial Transparent Film
Compatible models: DC12V exclusive, standard radio plug JASO
Materials, specifications, etc.: Film antenna part, transparent sheet
Manufacturer: Archhill
installation method
● Before work, please remove the battery side and work on the power supply to prevent shorts.. ● Determine where the film antenna is applied to the glass of the vehicle. Make sure that the power supply unit (connector connection part) is within 25mm from the pillar.. Also, please separate 15cm or more from other antennas.. The direction to paste can be vertical or horizontal. Wipe off the dirt on the pasted surface, remove the pillat trim cover, etc., and warm the glass when the temperature is low.. ● Once the position is decided, peel off the peeling paper (sticky paper) of the film antenna, paste it inside the glass of the vehicle, and paste it inside.
Please adhere to the glass even from the top of the film with a cloth, etc.. ● Please peel off the transparent protective paper slowly. ● Peel off the peeling paper of the black connector at the end of the cable of the booster part
Press and attach the connector terminal to the power supply unit (connector connection part) of the antenna so that the connector terminal is hit.. ● The cable should be wiring using the included code clamp without direct contact with the metal part.. ● Insert the antenna radio jack into the receiver. ● Please fix the booster body with double -sided tape, etc. to a place where it does not water or the like.. ● The red line of the power cable from the booster body should be connected to the electric circuit where the power is turned off when the engine key is removed.. ● Please fix the black line (earth) to the metal part such as the body..
Note
Radio waves may not be accepted in the area, model, receiver (radio), etc., and imported cars cannot be used.. If you replace it with a film antenna from a rod antenna, the sensitivity may drop.. AM may have noise etc.. Cannot be used for TV reception. It cannot be used for specialized glass that does not pass through radio waves by some vehicles (such as Celsior).
New article · unused item
Product specifications and designs may be changed without notice for improvement..
|