Free Shipping: T10 Single -sided light emitting 3 chip 4 consecutive LED blue 10 pieces
Auction ends | 2 days |
Bids | no |
Current price | ¥800 $6 |
Start price | ¥800 $6 |
Consumption tax | 0% included |
Seller | taichi6776 +11994 |
Condition | New |
Start time | 2024-04-30T21:41:44+09:00 |
End time | 2024-05-03T09:41:44+09:00 |
Auto-prolongation | Turned on |
Lot number | s1117904356 |
Seller position | Ibaraki Prefecture |
This product is a T10 one -sided light emitting 3 chip 4 consecutive LED blue. For 12V. It is a bulk product. In the photo, there are 11 pieces, but one is a pre -warranty such as damage during transportation.. (We check the lights before packing. )
It is very bright because it uses six SMDs of 3 chip type (three locations in one chip).. Bulletin warning light Cancellar resistance is built -in. A warning light may be attached depending on the vehicle type and the installation location.. In addition, since the fever generates is greater than the normal one for the canceller resistance, it cannot be used in a heated place.. Please be careful. LED has a polarity. If it does not light up, please insert it on the opposite. If the pin inside the socket is deformed, it may not be able to contact well and may not light up. Please do not touch the LED part at the time of installation. Please make sure that the mounting part is DC. Cannot be used in exchange. Most motorcycles under 125cc are mixed DC exchange. Please use the DC wiring again and use it. Since the LED is sensitive to heat, it cannot be continuously lit in hot places such as small sealed spaces. Please note that some models with high voltage are not available. We are not responsible for any damage or damage of vehicles due to installation.* Can be shipped on the day by payment until 13:00.
It is very bright because it uses six SMDs of 3 chip type (three locations in one chip).. Bulletin warning light Cancellar resistance is built -in. A warning light may be attached depending on the vehicle type and the installation location.. In addition, since the fever generates is greater than the normal one for the canceller resistance, it cannot be used in a heated place.. Please be careful. LED has a polarity. If it does not light up, please insert it on the opposite. If the pin inside the socket is deformed, it may not be able to contact well and may not light up. Please do not touch the LED part at the time of installation. Please make sure that the mounting part is DC. Cannot be used in exchange. Most motorcycles under 125cc are mixed DC exchange. Please use the DC wiring again and use it. Since the LED is sensitive to heat, it cannot be continuously lit in hot places such as small sealed spaces. Please note that some models with high voltage are not available. We are not responsible for any damage or damage of vehicles due to installation.* Can be shipped on the day by payment until 13:00.
Time | User | Price |
No bids | ||