Material: Brass

　　　　Outline size: Diameter 26mm Thickness about 10~12mm

　　　　Marking surface size: Vertical 25mm×Horizontal 25mm

　　　　Depth of Insertion Surface: 3mm

　　　　Mounting shaft diameter: 9mm (shaft stopper)

　　　　Attached : Hex wrench

　　　　Applications: Leather, woodworking, cloth, paper, etc.

    -------------------------------------------------------------------

    When using it as a branding, it is necessary to prepare the following items. - A commercially available soldering iron about 100W (trowel tip diameter 9mm) with a replaceable trowel tip 　

　　　　Recommended soldering iron: Ishizaki Electric Manufacturing Co., Ltd. SURE Shure SS-102I 100W

    ● Power controller (useful to have)

　　　　Recommended controller: goot power controller PC-11

    -------------------------------------------------------------------

     When using it as an engraving, please remove the shaft. ※※※※ The images may be used multiple times, so they may use the same one. ※ ※ ※ ※

■ We will also accept branding orders. Please do not hesitate to contact us. ■ Some other points have been exhibited, so please take a look if you like.

	Notes
The seal will be very hot. There is a risk of burns, so wear work gloves, etc. Handle with care. When attaching the shaft and marking surface, firmly fix the screws on the side of the marking surface with the included hex wrench to prevent the shaft from falling out. For installation on the solder paddy, insert the axis firmly to the seal and attach it. When engraving on leather, etc., please press it with a vice. The stamp may damage the seal. Both the branding and engraving should push the trial and check it, and then press the book. At the time of branding, the temperature and the number of seconds to be pressed are severe, and it is highly established that if you do not try pushing, you will fail. There may be small scratches at the time of production, but there is no effect on branding and engraving. Because it is made of brass, it discolors after heating.