Material: Brass

     Size: 15mm square (15mm vertical x 15mm wide x height 10mm)

     Seal depth: 3mm

     Mounting axial diameter: 4mm screw type (tap processed)

     Use: leather, woodwork, cloth, paper, etc.

    -------------------------------------------------- -------------------

    When using it as a branding, you need to prepare the following items.. ● About 40W of commercially available soldering (trowet 4mm) Items that can be replaced

    ● Power controller (convenient)

    -------------------------------------------------- -------------------

    This product is recommended to use it as a stamp because there are many shallow lines. Please remove the axis when using it as a stamp. ※※※※ The images may be used multiple times, so they may use the same one. ※ ※ ※ ※

■ We will also accept branding orders. Please do not hesitate to contact us. ■ Some other points have been exhibited, so please take a look if you like.

	Notes
The seal will be very hot. There is a danger such as burns, so wear a gloves, etc. Please be careful when handling. For installation on the solder paddy, insert the axis firmly to the seal and attach it. When engraving on leather, etc., please use it with a vise etc.. The stamp may damage the seal. Both the branding and engraving should push the trial and check it, and then press the book. At the time of branding, the temperature and the number of seconds to be pressed are severe, and it is highly established that if you do not try pushing, you will fail. There may be small scratches at the time of production, but there is no effect on branding and engraving. Because it is made of brass, it discolors after heating.