☆ Fender usa duo-sonic (MusicMaster mod) 1977 ☆ Red ☆ Vintage ☆ Restore & MOD product
| Auction ends | 2 days |
| Bids | no |
| Current price | ¥180,000 $1,252 |
| Start price | ¥180,000 $1,252 |
| Buy-now | ¥280,000 $1,947 |
| Consumption tax | 0% included |
| Seller | french_zipper +5480 |
| Condition | Used |
| Start time | 2024-04-28T21:54:33+09:00 |
| End time | 2024-05-05T21:54:33+09:00 |
| Auto-prolongation | Turned on |
| Lot number | d1100586340 |
| Seller position | Tokyo |
☆ Fender usa duo-sonic (MusicMaster Mod) 1977 ☆ Red ☆ Restore
I am discarding it for the end of life, and I am gradually putting out the guitar and collection I used at work,
High quality ones sell directly because they want an acquaintance.
Suddenly, the exhibition will be canceled, but please get along ~ ♪
Also, if you really want it, we will post additional photos and information.
I would be grateful if you could contact us from the question column ♪
A guitar studio who can trust the parts that were tattered and missing the parts.
Have the original parts or parts close to it select
It was a restore while adding a little MOD.
The final design is aimed at a design like Bronco..
When you line up with the red bronco, it looks like twins ♪
〇 neck:
・ Music Master 1977 Is it attached to Mustang?
It was replaced with rock nuts and valuable fingerboards were cut off, so
We have you restore with similar rosewood as possible..
Since the serial is [S7XXXXX], it is released in 1977..
・ The fingerboard is ordinary rosewood, but I feel that it is a fine and high quality..
・ Is the fret original? It seems that it has not decreased so much,
There is no terrible unevenness, there is no chatter or particular trouble.
・ The pegs attached were cheap and sick, so closed the screw holes.
Attach the same new F -key peg as the original that was stocked
Since it is returned to the original state, the operation is good ♪
・ Since the neck date is [4772], it is Tuesday 47, 1977..
It seems that there is room for the rod, but there is plenty of room,
The ones from this era are like a relatively hard maple and don't worry about warping ♪
At present, the string height has been set low in a small order of promises,
The condition of the fret is also good, so I don't feel chatter or clogging.
However, it depends on your string brands and gauges, so
Please adjust and use at any time.
〇 Body:
・ The body of the vintage music master depends on the time
It seems that the process itself may change completely depending on the lot,
In some cases, the internal zaguri is shared with the duosonic
Extend to control from one pickup dedicated to music masters
There is a simple thing that has a groove.
For music masters, Mustang and Duosonic
It is similar to the series and has a different part, and in this era, even if there is a contour.
It's not strange, but there is no contour like Mustang in the 1960s..
However, it is not particularly heavy, it is an interesting individual..
・ About this individualWhat was the simplest type,
The previous owner added a rear pickup,It seems that I was using it
The rear pickup Zaguri is dug by amateur work,
The work was rough, soHave them repaired to some extent,
Like MustangFor the entire ZaguriI had you put a copper foil shield, so
Noise and hamReduced compared to ordinary music masters, etc..
・ The bridge was a valuable type that was not recurring.
There are some rust, but maintenance and the new screws move normally, so
I think you can use it without any problems ♪
〇 Assembly:
・ At the stage of obtaining, the hole in the rear pickup has been pierced,
Only one original VOL pot, there is no pickup.
It was only a black pickguard, so I decided to mode it.
The design is similar to the pickguard of the music master of this age,
Based on the 1967 Bronco pickguard of Junk, which was left over,
To make a duosonic, make a hole in the mini SW and with the original pickguard.
I used a modified shape to the same shape.
・ VOL pot remained original, but TONE was missing, so
Here, the same CTS pot in recent years was attached, and the capacitor was stocked.
Attached 0.5μF100V of the same age (commonly known as Circle D) of the same age..
・ Pickup was considered practical in duosonic, so I thought about practicality.
From dozens of stocks, pickups of Fender USA from the 1980s and 1990s,
The front is around 6kΩ, the rear is around 9kΩ, and
I decided to set up the recent amplifier situation. ,
In case
In case
・ The circuit itself adopts the vintage Diosonic wiring.
The front Rear
At first glance it is a cheap and cute impression, but the sound is quite a variation
I guess it was one that could be used for live performances ♪
〇 Others:
・ The weight is relatively lightweight at 3.1 kg, it is easy to use, and the balance is good.
If you are looking for a light vintage, it may be a recommended guitar,
There are no other cases, but we will do the packing carefully, so don't worry..
Those who are looking for a new quality, those who are too nervous, and different from what they thought after receiving a successful bid.
Those who impose their subjectivity and seek complaints, returns and refunds,
If you have a successful bid and start using it yourself, if you are insane who can complain that a problem has occurred,
(I used to make a complaint that the sound disappeared after more than six months.. . )
Thank you not to be bid for my exhibition.
Regarding the delivery method, only the Yu -Pack cash on delivery..
We are not a guitar workshop, a music store, nor a recycle shop..
No claim & no return, thank you m (__) m
Thank you! !
| Time | User | Price |
| No bids | ||
