Instructions (English) are included.
Operating voltage: 3.6 to 8.5V
Size: 41x21x8mm(Not included)
Weight: 7g (without antenna)
Corresponding transmitter(The operating channel will be up to the maximum channel that the transmitter supports. )
Air:18mz・ 18sz・ 16SZ・ 14SG・ 10J・ 8J・ 6J・ 6K
Preparation of transmitter
Set the communication system of the transmitter to S-FHSS.
Pairing method
1. Turn on the transmitter. 2. Turn on the receiver power while pressing the F/S button of the receiver.. 3. Release the F/S button of the receiver. When the LED turns green, the pairing is completed.
S.BUS settings
S.BUS is invalid in the initial settings. How to enable S.Bus
1. Turn off the power of the transmitter. 2. Turn on the receiver. 3. Press the F/S button of the receiver for 6 seconds to let go. (LED green flashes. )
Four. Press the F/S button of the receiver for 1 second to let go. (LED red light is finished. )
If S.BUS is enabled, each port of the receiver works as follows..
Operating channel
CH1 to CH5 can be used with a regular servo. CH6 is only for S.BUS signal. Cannot be used except for S.BUS compatible servo & gyro. How to distinguish and invalidate S.BUS settings
1. Turn off the power of the transmitter. 2. Turn on the receiver. 3. Press the F/S button of the receiver for 6 seconds to let go. If S.BUS is enabled, the LED green flashes at a high pace of 5 times per second.. If S.BUS is invalidated, the LED green flashes at the slow pace of twice a second..
* You can guarantee quality as an imported product. Please note that new unused, manufacturing, transportation, and storage may have some scratches, etc.